Show Posts
Pages: [1]
1  Main Forum / General Discussion / Advice on selling PC on: November 10, 2013, 01:46:02 pm
Hello.  We are considering selling our 2013  PC 2551. There is no rush to sell, and we absolutely love our PC ( we've owned two, 2100 and now the 2551), and eventually plan on owning again.  I notice there is a For Sale section here on the forum.  My question is:  Has anyone sold a PC using the forum? It seems to be very well organized with PC able to offer trade-in and financing options.
Any input would be greatly appreciated.
Thanks
2  Main Forum / General Discussion / Re: Cruise control on: June 01, 2013, 08:56:02 am
You guys are great. Thanks for all the the comments. PC IS WORKING!  The service center crew were careful with our baby.  Ron, thats a classic movie!
3  Main Forum / General Discussion / Re: Cruise control on: May 31, 2013, 11:26:51 am
To update y'all. The Ford service center diagnosed a faulty clockspring and at this time I'm sitting in the waiting room as the new part is installed. Hope and pray that will be the fix. In searching other forums this part has been the focus of a recall several years back.
Again, thanks much for the input.
4  Main Forum / General Discussion / Re: Cruise control on: May 25, 2013, 05:43:27 pm
Very helpful information. I'm quite new to RVing, and Phoenix. Just great to know that we can find so much knowledge in one place. I'll definitely be "cruising"through these pages to soak up as much as I can.
Thanks again.
5  Main Forum / General Discussion / Re: Cruise control on: May 25, 2013, 10:33:47 am
Thanks again for that phone no. To Ford RV Assistance. They were very helpful and we now have an appt at a close by Ford dealer. Maybe we need to forward that info to Phoenix.
6  Main Forum / General Discussion / Re: Cruise control on: May 23, 2013, 07:18:05 am
Thanks much! We will definitely give them a call.
7  Main Forum / General Discussion / Re: Cruise control on: May 22, 2013, 05:22:29 pm
Ron,
Thanks for the ideas. I've opened both panels, but did not think of swapping relays. I need to update my profile...we traded in the 2006 for a  2013 2551, picked it up at the factory the first week of May. I noticed the problem on the way back to TX.  In searching the many forums out there, the clockspring is mentioned as the most likely culprit (all electric from steering wheel -horn, cruise , and the airbag, pass through it.)
The local ford dealership will not service it. This seems to be an obvious Ford warranty issue. So we are in a bit of a jam here as we need to get it inspected and tagged or pay a late fine.
Larry
8  Main Forum / General Discussion / Re: Cruise control on: May 22, 2013, 03:43:53 pm
Bob,
Sorry it took so long to get back..been busy at work.  No resolution, All fuses good. Looked under dash and did not come across any loose wires etc. I did not remove the cover on the steering column, will look there next..have to be careful with that airbag.
Thanks,
Larry
9  Main Forum / General Discussion / Re: Cruise control on: May 14, 2013, 07:47:00 am
Thanks Bob. Tonight after work Ill surely take a look at that area. I did ask the factory to have their electric guy give some ideas.
Larry
10  Main Forum / General Discussion / Cruise control on: May 13, 2013, 11:01:44 pm
Hello. We are new members to the cruiser family . In early May we picked up our new 2551, getting acquainted and loving it.
On the way home to Texas noticed that the airbag light was illuminated, but was not too worried. More concerned with the long drive ahead. Then about three hours out of Elkhart, I tried to engage the cruise and it and horn would not function.
We have contacted the factory and waiting on some guidance. In the meantime thought I should throw this out here for any ideas/wisdom. Have looked at some fuses (horn). No obvious cruise control fuse.
I need to get this resolved soon so I can get the cruiser inspected and licensed.
Thanks
Larry
Pages: [1]