Show Posts
Pages: 1 [2] 3 4 ... 15
16  Main Forum / General Discussion / Re: First trip on our 2350: a report on: November 12, 2013, 11:45:31 am
For some strange reason, PCs are also considered class B--not C.
17  Main Forum / General Discussion / Re: Generator won't start on: October 21, 2013, 11:29:24 am
I believe there is a breaker on the generator.  I will check my manual, and report back.
18  Main Forum / General Discussion / Re: Back up camera and monitor on: September 29, 2013, 07:54:49 pm
The lights are sealed with caulk.  A putty knife and light pressure moving around the light will loosen it.
19  Main Forum / General Discussion / Re: Back up camera and monitor on: September 29, 2013, 10:40:44 am
Bruce, what you're experiencing is exactly what happened with my previous pc.  For me, the problem was corrected by disconnecting, reconnecting and taping the cable connection at the rear of the pc (someone else on this forum suggested I do that).  The camera cable connects to a longer cable in the empty space inside the back of the pc.  I unscrewed the top tail light below the camera, and pulled the cable up until the connection appeared.  There's plenty of slack in the cable to do this.  Once I did that, the camera/monitor worked perfectly.
20  Main Forum / General Discussion / Re: Vvvvvvvvvvibration Noise on: September 19, 2013, 09:56:00 pm
Just a last straw thought--could the noise be caused by the tires being out of round?  Tires are not truly round, and sometimes on cars they cause vibrations until they are trued up or replaced..??
21  Main Forum / General Discussion / Re: video camera has a blue screen and no video on my last leg coming home on: September 16, 2013, 10:01:06 pm
The cable I mentioned connects to the camera in the cavity in the back of the PC.  The camera has a short cable that connects to a longer cable that goes down the back, under the bottom and up to the monitor.  The slack in this cable can be pulled up by removing the light where the cable enters the back of the PC.
22  Main Forum / General Discussion / Re: video camera has a blue screen and no video on my last leg coming home on: September 15, 2013, 09:31:38 pm
I had this problem on my first PC.  Someone on this forum advised me to pull the cable from the back of the PC and check the connection to the cable going to the front.  I pulled the cable by removing one of the top lights, unhooked/reconnected the two cables, taped them to make sure the connection was tight and stayed tight, and the monitor worked perfectly thereafter.
23  Main Forum / General Discussion / Re: A New Banging Sound After Year #6 - Dead Center In The Headliner Area on: September 13, 2013, 06:24:55 pm
You're right, Ron--as we've said over and over on this forum, the PC after sale service is almost beyond belief.  When I drove into the factory unannounced with the noise in my 2350 cap, they immediately started working on finding the problem and fixing it.  It took several hours and 2 people working non-stop until they did get it fixed.  When I tell people about this experience, they're amazed I didn't have to make an appointment and wait several days to get it fixed.   
24  Main Forum / General Discussion / Re: Inductive stovetop anyone? on: September 12, 2013, 04:44:06 pm
We bought an inductive stovetop from Camping World when they were on sale, and our experience with it has been great.  Wife's only comment was why didn't we get one sooner.  We use it inside the PC and outside when camping.  Just remember you can't use pots that magnets don't stick to (or to which magnets don't stick in case my old English teacher reads this).
25  Main Forum / General Discussion / Re: First Impressions 2552 on: September 10, 2013, 10:10:51 am
The popping of the left arm when being extended is normal.  I was told it's because the PC side is curved and the awning is built for a flat surface. 
26  Main Forum / General Discussion / Re: A New Banging Sound After Year #6 - Dead Center In The Headliner Area on: September 07, 2013, 11:33:19 pm
Yes, my 2350 was only a few months old when the noise started.  The noise was actually a creaking noise--the rubbing of the cap against the metal cab.  THe repair job lasted the next 2 years I had the PC, so they did a good job fixing it.
27  Main Forum / General Discussion / Re: A New Banging Sound After Year #6 - Dead Center In The Headliner Area on: September 07, 2013, 11:56:23 am
Ron, on my 2010 2350, the cap started making a rattling noise.  By the time I got from AZ to the factory, it had become a VERY loud noise.  They took out the cabinets and put in additional screws in the cap/cab.  It took them about 4 hours and many more screws/test drives before the rattle stopped.  Hope that's not your problem, because it was quite a job getting it fixed. 
28  Main Forum / General Discussion / Re: Problems with Norcold refrigerator door on: August 22, 2013, 10:47:17 pm
Don't have a picture, but what I did was take the door off the hinge and epoxy the broken piece back together.  After it dried, I put the door back on the pin hinge and filled the open void in the door piece with epoxy.  After it dried, I painted it black.  Didn't have a problem with the repaired door, but I did trade it in the next year so don't know the longevity of the repair.  One thing I should point out, the door insert that PC puts in the decorative front slip of the door is VERY heavy.  That could also contribute to the breaking door part.  The replacement door was light (weight) until I put the decorative piece back in the door front.  All in all, be happy, don't worry...
29  Main Forum / General Discussion / Re: Problems with Norcold refrigerator door on: August 22, 2013, 10:05:13 am
Tom, as noted earlier, the plastic piece that breaks is  on the fridge door, not the hinge bracket and pin attached to the fridge frame.  The door piece broke on my prior 2007 and 2010 PCs.  Maybe they changed the design in 2013, but my current 2012 has the same plastic door part that breaks.  The epoxy fix worked on the second break on my 2010 PC, so I now travel with epoxy "just in case".
30  Main Forum / General Discussion / Re: Problems with Norcold refrigerator door on: August 21, 2013, 02:14:53 pm
Sparky, unless you have a totally different fridge, the metal part is the pin.  The molded plastic piece on the door is the part that breaks.  That's why I'm surprised there is a repair kit.  Norcold sends you a complete door when the part breaks.
Pages: 1 [2] 3 4 ... 15