Show Posts
Pages: 1 2 [3] 4 5 ... 42
31  Main Forum / General Discussion / Re: 2014 Phoenix Crusier Rally on: January 29, 2014, 11:12:31 am
Bob and Peg,
We plan to--we will make reservations next month. We plan on reserving in the new campground in Promised Land. We stayed in the new one in 2012 on the way home and it was much better than the other one. I can't remember the names of either but they are both in Promised Land.

At this point, it looks as if it will be June 27 and then head to Mattapoisett on the 28th.

Judi
32  Main Forum / General Discussion / Re: 2014 Phoenix Crusier Rally on: January 29, 2014, 10:16:16 am
If the timing were right, we would be interested in meeting up for a East Coast get together.

RKS,
We just made our reservations for Blackwoods Campground at Acadia NP for 7/29 leaving on 8/3. Right now, the only firm commitment that we DO NOT have is for Orr's Island Campground for the month of August.

We always enjoy meeting PC owners. Our first PC was a 2350 on the Sprinter chassis--that was our first motorhome as well. Always had sailboats and power boats.

If you will be around in July/Aug send us a note and we will try to hook up.

Judi
33  Main Forum / General Discussion / Re: 2014 Phoenix Crusier Rally on: January 28, 2014, 04:06:03 pm
Jim and Beth,

We are going to be at the Wild Duck Campground in Scarborough, ME 7/22-7/29 then we head to Acadia NP for 5 days and then on to Harpswell ME for all of August.

After that, our plan is to head to NH, VT and upstate NY and then on home to FL.

Send me a PM if that would work with any of your summer plans.

Judi
34  Main Forum / General Discussion / Re: Awning Support on: January 26, 2014, 03:38:52 pm
After giving you a helpful , I should have said thank you. I also have one on order now.

George
35  Main Forum / General Discussion / Re: Phoenix Cruiser wants your 2552! on: January 25, 2014, 12:09:10 pm
Those on the for sale page are listed by owners. They may be gone but not deleted. The contact is the owner not the factory.

The post from Aimee  was, basically, anyone interested in trading their 2552 in for a larger or newer unit.

Judi
36  Main Forum / Tips and Tricks / Re: Transfer Switch Manual on: January 24, 2014, 11:54:11 am
The transfer switch is located at the base of the angled wall behind  the drivers seat. You can access it by removing the carpeted base of the wall. You can view it in one of Earl's videos.

George
37  Main Forum / General Discussion / Re: Introduce Yourself! on: January 21, 2014, 06:05:05 pm
Joe,
We are also located in SW Florida. We have had 3 PC's in the last 4 years. We finally got it right with our 2910,

Welcome to the Forum and if you would like to take a look at our PC, please let us know. We would be more than happy to help with your decision. We tow a Honda Fit and it works out perfectly for us.

Judi and George
38  Main Forum / General Discussion / Re: Florida Travelers Winter of 2013-2014 on: January 18, 2014, 07:01:46 am
Holly,

When you get to the West Coast of Florida, give us a shout. We are located about 2 miles west of 75 in Punta Gorda (between Ft. Myers and Sarasota)

Judi
39  Main Forum / General Discussion / Re: Phoenix at Tampa Super RV show today on: January 15, 2014, 07:26:12 pm
Sorry we missed meeting you. We were there, as well! We met Barry and Sue as they were exiting the Leisure Travel Vans and we all agreed that we were VERY happy with our PCs.

Judi and George
40  Main Forum / General Discussion / Re: Refrigerator always give a fault message when traveling on: January 15, 2014, 07:22:55 pm
I finally solved our problem by adjusting the propane ignition wire. Our fridge would light, run, then shutdown. The wire has some kind of fuse that shuts off the gas. The igniter had loosened. Have not had the problem since.

George
41  Main Forum / Tips and Tricks / Re: leak at awning on: January 10, 2014, 07:59:58 pm
Update on leak

I've talked to Kermit. His initial thought was it may have been caused by water following the awning power cord. I explained, I never got that high with my spray bottle of water.

Kermit said that there should be no problem removing the screws from the awning slide with the awning open. Today, being cautious, I first removed the screw at the top of the wedge then the two screws at the bottom of the wedge. The wedge fell out. The screws had rust stains on them.

Looking  closer at the awning slide, I realized that the upper section (the part where the support arm comes out) does not lay flat on the wall. The wall has a concave surface.  I desided to remove the four screws above and below the support arm. All but one screw was rust stained. I caulked all screw holes before installing the screws. I ran a bead of caulk down both sides of the awning slide and on top of the wedge, hopefully stopping any water leak.

George
42  Main Forum / Tips and Tricks / Re: leak at awning on: January 04, 2014, 12:27:30 pm
Mike;

The wedge I'm referring to is at the low end of the awning rail. The wedge is a filler. I believe it is welded to the awning rail. With the awning open, I have two screws at the bottom of the rail and one at the top of the wedge. I believe that I can back these screws out and separate the wedge and the rail from the wall of the coach. Hopefully, I will have enough room to put in some sealer and stop the leak.

Skipper;

This does sound like the leak that the previous owner had. You might want to look at the floor area behind the corner desk or remove the desk cabinet from the wall and look for any rust.  I removed the carpeted bottom section of the angled wall and the staples had rusted away.

George ,
43  Main Forum / Tips and Tricks / leak at awning on: December 31, 2013, 09:35:37 am
I recently found water on the floor at the angled wall behind the passenger seat. I first thought it was from the roof. After further inspection, I removed the carpeted bottom plate and dryed the area. I got a 1/2 pint spray bottle of water. Starting low at the awning, I sprayed up the awning slide. At the wedge, the water was leaking in behind the wall to the floor.

I have not tried to seal this until I talk to Kermit. I'm thinking of loosening the screws to seal behind the wedge.

George
44  Main Forum / General Discussion / Re: MICHELIN TIRE RECALL on: December 29, 2013, 04:34:51 pm
It was $1 per tire, $7 for 7 tires! No big deal
45  Main Forum / Photos / Re: Merry Christmas!! on: December 26, 2013, 05:51:01 am
Beautiful. We finally got reservations for Curry Hammock next Novemmber!

Merry Christmas!!

Judi and George
Pages: 1 2 [3] 4 5 ... 42