Pages: 1 [2]   Go Down
Print
Author Topic: Water Drain valves on 2350  (Read 1425 times)
billy
SuperHero Member
******

Helpful Rating: 72
________
OwnPC: Yes
NewUsed: New
PurchDate: Feb, 6 2011. Same day Packers won super bowl
Model: 3100
Slide: Yes
Location: Coarsegold, Ca. About 20-25 miles S/W Yosemite
________
Posts: 760


Best Friends


View Profile
« Reply #15 on: March 01, 2011, 11:57:34 am »

"The two drains in the floor that are together, drains the pressured plumbing.  You open those valves and open all faucets, both hot and  cold, and don't forget the outside shower too.  Gravity drains it all.  It is for winterizing purposes."

Where are these two valves located? Does anyone know if they are on the 3100? Guess I'll spend some time on my back and get acquainted with the underside of my rig.

Logged

Insanity: Doing the same thing over and over and expecting different results.
ron.dittmer
SuperHero Member
PCPC
*******

Helpful Rating: 167
________
OwnPC: Yes
NewUsed: New
PurchDate: June 2007
Model: 2350 Ford
ModelYear: 2007
Slide: No
IntColor: Cherry&Green
ExtColor: FullBody Gray
Location: Dundee, IL
________
Posts: 1890



View Profile WWW
« Reply #16 on: March 01, 2011, 01:09:38 pm »

Billy,

If nobody gives you the answer you are looking for with your model 3100, try this.  If you are nimble enough to crawl under your rig, look for a pair of rubber or plastic drain tubes that come out from the floor and hang down maybe 6" or so.  That would help you figure out where the drain valves, are as the tubes hang directly below the valves inside.

Don't confuse the pair with the single tube that drains the fresh water tank.
Logged

Ron Dittmer (wife Irene) 2007 Model 2350 Without A Slideout
Our Rig Is Available For Viewing Any Time Of Year In Dundee, IL
Stored At Home In Our Heated Garage (Well-Lit & Warm Comfort In Winter)
mciai2000
SuperHero Member
******

Helpful Rating: 41
________
OwnPC: Yes
NewUsed: New
PurchDate: 09/2011
Model: 2552
ModelYear: 2012
Slide: Yes
IntColor: grey
ExtColor: full body night shadow
Location: Pennsylvania
________
Posts: 360



View Profile
« Reply #17 on: March 05, 2011, 09:34:02 pm »

Guys:

Sorry I have not responded sooner.  Very busy at work with all kinds of winter claims(insurance agency).  Anyway, Yes the bypass for the water heater keeps the antifreeze out.  Drain the tank and keep the antifreeze out. Cost less.  The bypass I meant is really a siphon tube that hooks into the water pump to draw the antifreeze into the system.  You stick the tube into the antifreeze solution and suck it in.  Without that tube the project becomes much more laborious. 

David
Logged

family is a passion...work is a requirement
2012 2552 full body paint(Phoenix # 2)
billy
SuperHero Member
******

Helpful Rating: 72
________
OwnPC: Yes
NewUsed: New
PurchDate: Feb, 6 2011. Same day Packers won super bowl
Model: 3100
Slide: Yes
Location: Coarsegold, Ca. About 20-25 miles S/W Yosemite
________
Posts: 760


Best Friends


View Profile
« Reply #18 on: March 11, 2011, 11:01:25 pm »

I email Amanda, Kermet called. The water heater by-pass and the drains are under a kitchen drawer. billy
Logged

Insanity: Doing the same thing over and over and expecting different results.
TomHanlon
SuperHero Member
PCPC
*******

Helpful Rating: 171
________
OwnPC: Yes
NewUsed: New
PurchDate: 11/11/11
Model: 2552
ModelYear: 2012
Slide: Yes
IntColor: Cherry
ExtColor: full paint Cafe
Location: Maryland
________
Posts: 1039



View Profile
« Reply #19 on: March 12, 2011, 05:43:14 am »

Billy, The drain valves in all PCs are in the same place, under the Kitchen sink. You remove the left bottom draw. To get the draw out you have to push down on the black trangle on one side and pull up on the other side, while sliding the draw out. You will see three valve, one in a cross pipe, you need to turn all three valves to bypass the water heater.
Logged

Tom Hanlon
Current PC 2012 2552 Full paint Cafe
First PC 2010 2350 Full paint Umbra
Anne and Bob
Sr. Member
****

Helpful Rating: 9
________
OwnPC: Yes
NewUsed: New
PurchDate: May 21, 2012
Model: 2551
ModelYear: 2013
Slide: Yes
IntColor: cafe
ExtColor: cafe
Location: Port Townsend, WA
________
Posts: 70



View Profile
« Reply #20 on: July 25, 2012, 10:48:16 am »

  Help  I must be REALLY DUMB.  I cannot figure out how to remove the drawer under the kitchen sink.  There are black triangles at the end.  I tried pushing them in and it didn't work.  I tried pulling them out and it didn't work.  I have never seen this type of drawer mechanism before.  There must be a simple answer but guess I am too old to figure it out!!!  Help!

Anne
Logged
TomHanlon
SuperHero Member
PCPC
*******

Helpful Rating: 171
________
OwnPC: Yes
NewUsed: New
PurchDate: 11/11/11
Model: 2552
ModelYear: 2012
Slide: Yes
IntColor: Cherry
ExtColor: full paint Cafe
Location: Maryland
________
Posts: 1039



View Profile
« Reply #21 on: July 25, 2012, 11:44:49 am »

Push down on one side (I believe it is the right side) while pulling up on the other side and pulling out the drawer. I marked my drawer after finding which was up and which was down.
Logged

Tom Hanlon
Current PC 2012 2552 Full paint Cafe
First PC 2010 2350 Full paint Umbra
Pages: 1 [2]   Go Up
Print
 
Jump to: