Pages: 1 [2]   Go Down
Print
Author Topic: What Is That Banging I've Been Tollerating For The Past 3 Years?  (Read 2300 times)
gl1500
Hero Member
*****

Helpful Rating: 45
________
OwnPC: Yes
NewUsed: New
PurchDate: May. 2014
Model: 2551
ModelYear: 2551/2014
Slide: Yes
IntColor: Hickory
ExtColor: Cafe'
Location: Idaho
________
Posts: 165


View Profile
« Reply #15 on: May 08, 2011, 08:46:42 pm »

We were in some heavy winds, both driving and parked, and heard a very loud banging.  Remembering what people had said about the antenna, I climbed up on the ladder to check it.  Guess what, it was not moving, but the banging was still there.  After searching for the location of the noise, I finally located it.  On our 2552, and many other units, there is a large steel plate that acts as a heat shield between the generator and the propane tank.  It was loose at the securing screws allowing it to swing in the wind and bang against the tank.  A check with PC and found it was not needed anymore because the extra foot of length from the 2551 to the 2552 gives plenty of clearance.  So I just took it off and sealed the screw holes.  No more noise.
      Bob
Logged
Pages: 1 [2]   Go Up
Print
 
Jump to: