Hello Guest

Liquid Tape

  • 2 Replies
  • 1124 Views
*

billy

  • ******
  • 760
  • Best Friends
    • View Profile
  • OwnPC: Yes
  • NewUsed: New
  • PurchDate: Feb, 6 2011. Same day Packers won super bowl
  • Model: 3100
  • Slide: Yes
  • Location: Coarsegold, Ca. About 20-25 miles S/W Yosemite
Liquid Tape
« on: September 06, 2011, 10:18:50 pm »
I got this hair brain idea; why not seal all the wires under the rig. Good idea, huh? I jacked up the rear as high as I could get. Got the port-a-gee creeper and started to work. Removed ground wires, clean and reinstalled AND then the liquid tape. This stuff works pretty well. Did all the OEM connecters, the ends, not the slip joints, the steps, under the back where the tanks are, a lot of work but hopefully it will pay off. The head will heal, no hair to scrap off just a little skin.
Insanity: Doing the same thing over and over and expecting different results.

*

aimee

Re: Liquid Tape
« Reply #1 on: September 10, 2011, 07:07:44 pm »
ouch! ((hug))  hope you heal soon, and that all the hard work pays off!

*

ron.dittmer

  • *******
  • 3564
  • Ron and Irene
    • View Profile
    • My 2007 2350 Phoenix Cruiser
  • OwnPC: Yes
  • NewUsed: New
  • PurchDate: June 2007
  • Model: 2350 Ford
  • ModelYear: 2007
  • Slide: No
  • IntColor: Cherry Green&Gray
  • ExtColor: Full Body Gray
  • Location: Illinois
Re: Liquid Tape
« Reply #2 on: September 12, 2011, 11:00:48 am »
I used silicone grease a few years ago, but this past spring when I wired in a back-up light switch, I noticed most of the grease was replaced with road grime.  My idea did not provide long lasting results.

Billy, Your liquid tape idea sounds much better.   2o2
Ron (& Irene) Dittmer