Pages: [1]   Go Down
Print
Author Topic: Liquid Tape  (Read 1119 times)
billy
SuperHero Member
******

Helpful Rating: 73
________
OwnPC: Yes
NewUsed: New
PurchDate: Feb, 6 2011. Same day Packers won super bowl
Model: 3100
Slide: Yes
Location: Coarsegold, Ca. About 20-25 miles S/W Yosemite
________
Posts: 760


Best Friends


View Profile
« on: September 06, 2011, 11:18:50 pm »

I got this hair brain idea; why not seal all the wires under the rig. Good idea, huh? I jacked up the rear as high as I could get. Got the port-a-gee creeper and started to work. Removed ground wires, clean and reinstalled AND then the liquid tape. This stuff works pretty well. Did all the OEM connecters, the ends, not the slip joints, the steps, under the back where the tanks are, a lot of work but hopefully it will pay off. The head will heal, no hair to scrap off just a little skin.
Logged

Insanity: Doing the same thing over and over and expecting different results.
aimee
Guest
« Reply #1 on: September 10, 2011, 08:07:44 pm »

ouch! Hug2  hope you heal soon, and that all the hard work pays off!
Logged
ron.dittmer
SuperHero Member
PCPC
*******

Helpful Rating: 321
________
OwnPC: Yes
NewUsed: New
PurchDate: June 2007
Model: 2350 Ford
ModelYear: 2007
Slide: No
IntColor: Green&Gray Cherry
ExtColor: Full Body Gray
Location: Land Of Lincoln
________
Posts: 3553



View Profile WWW
« Reply #2 on: September 12, 2011, 12:00:48 pm »

I used silicone grease a few years ago, but this past spring when I wired in a back-up light switch, I noticed most of the grease was replaced with road grime.  My idea did not provide long lasting results.

Billy, Your liquid tape idea sounds much better.   ThumbsUp
Logged

Ron & Irene Dittmer
Pages: [1]   Go Up
Print
 
Jump to: