Cruisers Forum

Main Forum => Tips and Tricks => Topic started by: billy on May 01, 2011, 06:22:02 pm

Title: Another project!
Post by: billy on May 01, 2011, 06:22:02 pm
I tied into the 12v light on the right, will install a rocker switch for the 12v rope lights over the inside cabinets. Along the sink I plan on a 110V plug just above the counter for toaster. Will come off the pug I installed where the fire ext was. I'll use the surface mount track for the 110v wiring and a surface mount box. We'll see how that goes?
Title: Re: Another project!
Post by: gl1500 on May 01, 2011, 08:26:58 pm
Billy,
   Make sure you use a GFI plug being that close to the sink.
     Bob
Title: Re: Another project!
Post by: billy on May 01, 2011, 10:08:27 pm
This plug will be wire off the one by the sink, (inverter) I think it is protected by the bathroom GFI. But thanks for reminding me, before I do it I'll check it
Title: Re: Another project!
Post by: billy on May 05, 2011, 08:39:03 pm
Finished the kitchen plug and the 12v rope lights